SmartGyro SMART-HELMET Bedienungsanleitung Seite 17

English
Remote control Bluetooth function
1 Adjust the fixation of the control on
the handlebar with its adjustable straps,
shown in image * 5
2 Turn on the smart helmet by
pressing any button on the controller.
3 Left turn signal: Press the left button if
you want to turn left. The indicator will
blink for 20 seconds.
4 Right turn signal: Press the right button if you
want to turn right. The indicator will blink for 20
seconds.
5 To go straight ahead: The button above changes the flashing light to a
steady light, it is used for when you want to cancel a turn signal beforehand.
6 Power off button: Please press and hold the on / off button on the
helmet for 2 seconds to turn off the helmet.
30
Left turn Go straight
Right turn
OFF botton
Note: If the helmet does not follow the light patterns, press a
button on the controller. If a small red LED light starts flashing, it
means that the helmet and controller are not paired or the
helmet has no battery.
A red LED will start flashing when you charge the helmet and will
turn off when the helmet is fully charged.
SmartGyro smart turn signals
1 Turn indicators: press any button on the
remote control (right, left or up).
2 Off button: Please press and hold the on / off button on the
controller for 2 seconds.
Bluetooth functions
1 Answer a call: When you are receiving a call, you
can press the "M" button to answer the call, it is
located on the chin strap.
2 Reject a call: When there is an incoming call, you
can hold the "M" button to reject the call, it is located
on the chin strap.
31