SmartGyro SMART-HELMET Bedienungsanleitung Seite 16

English
Reset mode. image * 3.
All the helmet's LED lights will start to flash rapidly, press
the reset button on the remote control (image * 4) and
the helmet is in Stand-By
Bluetooth function (only Pro)
Check that the helmet has battery, then follow
the procedures to pair the smart helmet with your
mobile phone.
28
1. press the "M" button on the strap until the red and blue LEDs
start to flash alternately (if the red LEDs start flashing first, it
means the helmet is on but the bluetooth is not) .
2. Now turn on the Bluetooth function from your mobile phone and
try to connect to the Bluetooth called "SmartGyro Helmet"
3. When you have successfully
connected, you will hear a voice
prompt saying: "Your headphones are
connected, and the blue LED will flash
every 4 seconds confirming that the
pairing was successful.
4. If left idle for 10 minutes, the helmet
will turn off.
29