IKEA FORKYLD AA-2242183-3 Bedienungsanleitung Seite 22

ENGLISH
Problem
Water flows on the rear plate
of the refrigerator.
There is too much condensed
water on the rear wall of the
refrigerator.
There is too much condensed
water on the rear wall of the
refrigerator.
There is too much condensed
water on the rear wall of the
refrigerator.
Water flows inside the refrig‐
erator.
Water flows inside the refrig‐
erator.
Water flows on the floor.
Water flows on the floor.
Water flows on the floor.
Temperature cannot be set.
The temperature in the appli‐
ance is too low/too high.
The temperature in the appli‐
ance is too low/too high.
The temperature in the appli‐
ance is too low/too high.
Possible cause
During the automatic de‐
frosting process, frost melts
on the rear plate.
Door was opened too fre‐
quently.
Door was not closed com‐
pletely.
Stored food was not wrap‐
ped.
Food products prevent the
water from flowing into the
water collector.
The water outlet is clogged.
The evaporative tray above
the compressor is not placed
below the melting water out‐
let.
Door was left open for a long
time.
The gasket is deformed or
damaged.
The "Fast Freezing function"
is switched on.
The temperature is not set
correctly.
The door is not closed cor‐
rectly.
The food products' tempera‐
ture is too high.
Solution
This is correct.
Open the door only when
necessary.
Make sure the door is closed
completely.
Wrap food in suitable pack‐
aging before storing it in the
appliance.
Make sure that food products
do not touch the rear plate.
Clean the water outlet.
Make sure the tray is placed
below the melting water out‐
let.
Open the door only when
necessary.
Contact the Authorised Serv‐
ice Centre.
Switch off "Fast Freezing
function" manually, or wait
until the function deactivates
automatically to set the tem‐
perature. Refer to "Fast
Freezing function" section.
Set a higher/lower tempera‐
ture.
Refer to "Closing the door"
section.
Let the food products tem‐
perature decrease to room
temperature before storage.
22