Startup Operations; Installation - Paj GPS VEHICLE FINDER2.0 Bedienungsanleitung

To do this, please go to
www.start.finder-portal.com
and follow the instructions.

2.4 Startup operations

Please observe the following points before connecting the device
to the vehicle battery:
SIM card is already in the VEHICLE Finder 2.0 4G

The VEHICLE Finder 2.0 4G should not be attached to fuel

lines or other combustible components.
No other components of your vehicle should be damaged by

the attachment.
Installing the VEHICLE Finder 2.0 4G on the vehicle to power

the device may discharge the vehicle's battery. Before
connecting, check whether your vehicle has a discharge
protection and retrofit it if necessary. In idle mode, the finder
requires approx. 10-20 mAh.
Please always observe the manufacturer's specifications for
your vehicle. Compensation claims due to incorrect

2.5 Installation

Please proceed as follows when connecting the Finder to your
car battery. The following figure serves as a guide.
1. Connect the VEHICLE Finder 2.0 4G to the cable harness
using the black plug-in function.
2. Connect the device to the battery. Connect
with the fuse to (+).
Attention! The poles must never be reversed.
connections are hereby excluded.
Connect the black cable to Minus (-).
Vehicle Finder 2.0 4G by PAJ with Online-Tracking V.1.0 EN
© PAJ UG (haftungsbeschränkt)
20
the red cable