Herunterladen Inhalt Inhalt Diese Seite drucken

Application Information; Cleaning Instructions - DJO AIRCAST AIRSELECT SHORT Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 6

APPLICATION INFORMATION:

A cotton or cast sock will enhance comfort – NOT INCLUDED
1) PREPARE BRACE –
Unfasten straps, remove front panel, and open liner.
2) APPLY BRACE –
While seated, place foot in brace. Position heel in back of brace. Wrap
liner around foot and then ankle (Fig. A).
Replace front panel: Position front panel so the Aircast logo is over the
toes and the foot panel is situated inside the brace. The upper part of
the panel should be secured outside the brace (Fig. B).
Secure straps from bottom to top (Fig. C). Tighten until snug and
comfortable.
3) ADJUST AIRCELL SUPPORT –
The SHORT walking brace aircells are initially deflated
Begin inflation on injured side first.
To inflate aircell, place finger on top of large inflation pump found on
either side of brace (Fig D). Pump until aircell feels snug.
Repeat on other side. Pump until aircell feels snug.
In the event of over-inflation, deflate aircells.
4) DEFLATE AIRCELLS –
To deflate aircells, press and hold finger on small release button
(Fig. E).
Deflate until pressure is comfortable.
NOTE: Deflate aircells before removing brace for proper fit when
reapplying.
NOTE: Higher pressure provides more support when walking, lower
pressure is more comfortable when sitting or reclining. Pressure
can also be adjusted by tightening or loosening straps.

CLEANING INSTRUCTIONS:

THE FOAM LINER MAY BE HAND-WASHED IN 86°F/30°C WATER WITH MILD
DETERGENT AND AIR-DRIED. DO NOT PUT IN DRYER OR USE OTHER HEAT
SOURCE TO DRY.
WARRANTY:
DJO, LLC will repair or replace all or part of the unit and its accessories for
material or workmanship defects for a period of six months from the date
of sale.
NOT MADE WITH NATURAL RUBBER LATEX
INTENDED FOR USE ON A SINGLE PATIENT
MATERIAL COMPONENTS
Shell: POLYPROPYLENE
Front Panel: HIGH DENSITY POLYETHYLENE
Straps: NYLON
Inflation Pumps: THERMOPLASTIC POLYURETHANE
Liner: NYLON/POLYURETHANE/POLYESTER (OUTER/FOAM/INNER MESH)
Binding: POLYESTER
Outer Sole / Insole: EVA/RUBBER
NOTICE: WHILE EVERY EFFORT HAS BEEN MADE IN STATE-OF-THE-ART TECHNIQUES TO
OBTAIN THE MAXIMUM COMPATIBILITY OF FUNCTION, STRENGTH, DURABILITY AND
COMFORT, THERE IS NO GUARANTEE THAT INJURY WILL BE PREVENTED THROUGH THE USE OF
THIS PRODUCT .
3

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis