Dismounting, Maintenance And Cleaning - Simfer Sm 5658 Bedienungsanleitung

GB

DISMOUNTING, MAINTENANCE AND CLEANING

You can dismount the unit for maintenance purposes and for disposal.
Follow the steps below to do this:
1. disconnect the unit from the power supply by pulling out the plug or turning
off the the power socket, e.g. by removing the fuse.
2. if available, loosen the screws of the shaft and dismantle it.
3. pull out the mains plug if necessary
4. remove the recirculation accessories (hose, clamps, air recirculation
diverter, etc.)
5. remove the hood from the wall. It is recommended that this process is done
by two people.
WARNING: Prior to each maintenance and cleaning, the
unit must be unplugged or the fuse to which it is connected
must be disconnected.
1. Pay attention to clean the appliance, especially immediately after cooking
fried foods.
2. It is sufficient to use a soft cloth soaked in liquid detergent to clean
the exterior of the unit.
3. Never use abrasive or scratching products for cleaning.
4. In order to preserve the surface quality of the unit, avoid using cleaning
agents containing methylated spirits, bleach and abrasive powder when
cleaning. On stainless surfaces; use special cleaning spray used for damp, soapy
cloths or preferably stainless surfaces.
WARNING: Without periodic cleaning, there is a risk of
fire and loss of yield.
18