Simfer SM 5658 Bedienungsanleitung Seite 10

GB
Body Mounting
Attach the mounting template to the wall at the distance (65 cm) shown in
Figure 1. Drill through points A and C with Ø8 mm drill bit. At the B points, drill
the chimney mounting plate with a Ø6 mm drill bit, considering the distance to
the ceiling and the maximum length of the flue.
Attach Ø8 mm dowel (5) to points A and C. Attach Ø6 mm (8) anchors to the
B points. Tighten the Ø5 x 50 mm screw (6) to the A points so that the distance
between it and the wall is 5 mm. Attach the product body to the screws at point
A and tighten the screws completely. Open the product cover and remove the
filters. Complete the body assembly by mounting Ø5 x 50 mm screws to the C
points (6).
Note: The suspension plate mounting shown in detail is optional. It
varies based on model.
3
2
1
9
10
4
7
8
6
5
10
Optional
Installatio
n
B
B
A
A
C
C