eta 005199010 Bedienungsanleitung Seite 18

GB
Insertion and removal (fig. 1)
The sharpener shaft and connect it to the respective hole in the
lower part of the drive to the maximum position (1 arrow) and
secure in by turning anticlockwise (2 arrow), you will hear a click.
Release the sharpener by pressing the release lock button
(3 arrow), and remove the sharpener from of the hand beater.
Use
When working, hold with one hand the hand beater and hold the
knife with the other hand. The recommended using speed is 3.
Place the blade of the knife (specifically the part nearest to the
handle) into the wheel by pressing lightly and gently pulling the
knife towards you (fig. 2a) for approximately 3 or 7 seconds. Once
you have performed this procedure 3 to 5 times, check that the
knife has been sharpened sufficiently. Please sharpen the knife
according to the shape of the blade, and don't use too much force
(ensure constant force and uniform speed). Repeat the procedure
until the knife has been sharpened to the desired degree. Once you
have finished, unplug the appliance and clean knife in hot water with
a detergent right after use, rinse it in clean water and wipe till dry.
WARMING
The knife must always be pulled through the
–
groove against the direction of movement of
the rotating rollers (fig. 2a).
When sharpening the types of knives and chisels
–
shown in picture no. 2b, do not sharpen the blade
all the way to the end, meaning all the way to the
handle!
In the case of very blunt knives or those with
–
damaged blades, they will need to be sharpened
using a more aggressive method, in which case
we recommend you to have them sharpened
professionally.
18 / 39