Control Panel; Before Using The Oven; Setting The Clock - Sharp YC-PC254A Bedienungsanleitung

CONTROL PANEL

1. DIGITAL DISPLAY – Cooking time, power, indicators and clock time are
displayed.
2. AUTO MENU keys – Press to select auto cooking menu. (Refer to page 17 for
advice on use).
3. START/QUICK START – (Page 14).
4. MICROWAVE POWER – Press to select microwave power level. (Page 14).
5. GRILL – Press to set grill cooking program. (Page 15).
6. MICROWAVE+GRILL – Press to set microwave and grill combination cooking
program. (Page 15).
7. CONVECTION TEMPERATURE – Press to select convection temperature.
8. MICROWAVE+CONVECTION – Press to select convection ombination cooking.
9. JOG DIAL – Use to set time of cooking or the clock.
10. STOP/ECO – Press once to temporarily stop cooking, or twice to cancel cooking
altogether. Use to set power saving mode. (Page 19).
11. CHILD LOCK – (Page 19).
12. TIME/SET CLOCK – Use to set clock time. Use to set timer function. (Page 13).

BEFORE USING THE OVEN

When the oven rst plugged in, beep will sound and the display will show "1:00". Note that the clock does not have to
be set for the oven to operate correctly. To set the clock, follow the instructions in the "Setting the Clock" section of
this User Manual.
When new, the very rst time the grill and/or convection is used, smoke and odors will be given o . To avoid this
happening when food is being cooked, use the grill and convection function without food for approx. 20 minutes.
• After opening and closing the door, the oven will enter the standby mode. If no buttons are press within 1 minute,
the display will remain on and the buttons will not operate. To enter standby mode again, open and close the door.
• During cooking, if the STOP/ECO button is pressed once, the cooking cycle will be paused. To restart cooking press
the START/QUICK START button. If the STOP/ECO button is pressed twice, cooking will be canceled.
• When programming the oven for a particular function and there is a pause between button presses of more than 30
seconds the oven will return to the standby mode.
• When a cooking cycle is completed, the display will show "End" and a tone will be heard every two minutes until a
button is pressed or the door is opened.

SETTING THE CLOCK

This oven has a clock which can be used in either 12- or 24-hour mode. To set the clock, follow the instructions as
below:
1. In standby mode, press and hold TIME/SET CLOCK button for at least 3 seconds to enter the clock setting mode.
2. Press the TIME/SET CLOCK button to select the 12- or 24-hour clock mode.
3. Use the JOG DIAL buttons to set the desired hours and minutes.
4. Press the TIME/SET CLOCK button to store and exit the clock setting mode.
• It is not necessary to set the clock for the oven to work normally.
• While in the cook mode, press the TIME/SET CLOCK button to see the time of day (if set). The time of day will
change back to the cooking count down after 5 seconds. Note that the time of day can not be viewed if the kitchen
timer has been set.
EN – 13 EN – 13
1
2
3
6
9
10
EN
4
5
8
7
11
12