Subwoofer Control Panel - Montarbo R Serie Bedienungsanleitung

R SERIES

SUBWOOFER CONTROL PANEL

5
7
1
2
4
5
1 CH1 BALANCED INPUT
6.35mm XLR/jack combo input for microphone and line signals.
2 CH1 LINK OUTPUT
Line output for audio signal link.
3 CH1 X-OVER OUTPUT
Crossover output for linking the audio signal to one head (speaker)
4 CH2 BALANCED INPUT
6.35mm XLR/jack combo input for microphone and line signals.
5 CH2 LINK OUTPUT
Line output for audio signal link.
20
8
9
11
10
3
6
6 CH2 X-OVER OUTPUT
Crossover output for linking the audio signal to one head (speaker)
7 LEVEL
This knob adjusts the output level, turn it to raise the level or lower it. In particular the
positions at 0 dB are indicated in the case of single system (INPUT 1) or stereo (INPUT
1 + INPUT 2).
8 POLARITY
If pressed, it allows you to invert the polarity (180°), which is normally in the 0° position.
9 X-OVER
Allows you to choose the crossover frequency for linking the signal to one
head. Pressing the key in succession enables one or the other cut-off frequency
(80 Hz/100 Hz).
10 CLIP LED
This LED lights up when the subwoofer signal is close to distortion. In this case reduce
both the MAIN signal and the active channels signal.
11 ON LED
This LED lights up when the subwoofer is connected to the mains and the power
switch is ON.
user manual
21