Speaker Control Panel - Montarbo R Serie Bedienungsanleitung

R SERIES

SPEAKER CONTROL PANEL

4
3
2
1
4
1 MIC/LINE INPUT
6.35 mm XLR/jack combo input for microphone and line signals.
2 LINE/MIC SELECTOR SWITCH
This selector switch can be used to adjust the input sensitivity.
3 CH1 LEVEL
This knob adjusts the level of channel 1, turn it to the right to raise the level, to the left
to lower it.
4 LINE INPUT
Input for line level signals with XLR-F connector.
5 LINE INPUT
Input for line level signals with 6.35 mm jack connector.
18
7
8
10
9
13
12
11
5 6
6 CH2 LEVEL
This knob adjusts the level of channel 2, turn it to the right to raise the level, to the left
to lower it.
7 PRESET LED
These LEDs indicate which preset is active between PLAYBACK, FLAT, BASS BOOST
and WEDGE.
These presets have been optimized for different applications. PLAYBACK is ideal for
listening to recorded audio and/or karaoke, FLAT is great for concerts, BASS BOOST
is perfect for playing rich low frequency audio, such as DJing and disco music, while
WEDGE is for use as a stage monitor.
8 PRESET
This button allows you to choose the optimal preset for your current application from
the four presets.
9 CLIP LED
This LED lights up when the speaker signal is close to distortion. In this case reduce
both the MAIN signal and the active channels signal.
10 ON LED
This LED lights up when the speaker is connected to the mains and the power switch
is ON.
11 MAIN OUTPUT
This XLR-M output provides a balanced line level signal, its signal is set by its selector
switch.
12 LINK/MIX
Through this selector you can choose whether the output signal to another speaker
must be the one present in the inputs (LINK) or the one mixed between the three input
channels and controlled by the MAIN (MIX).
13 MAIN LEVEL
This knob adjusts the output level of the active speaker.
user manual
19