Cleaning And Maintenance - Ferm WSM1008 Originalbetriebsanleitung

switching on and off (fig. A)
● To switch on the machine, keep the lock-off
button (2) pressed and simultaneously press the
on/off switch (1).
● To switch off the machine, release the
on/off switch (1).
Using the laser (fig. A)
The laser is used for projection of the cut on the
wall.
● To switch on the laser (9), press the on/off
switch (8).
● To switch off the laser (9), release the
on/off switch (8).
overload indicator (fig. A)
The overload indicator (10) indicates whether the
machine is overloaded.
● If the machine is switched on, the overload
indicator (10) flashes green 3 times.
● If the overload indicator (10) lights green, the
machine is not overloaded. The machine can
be used normally.
● If the overload indicator (10) flashes red, the
machine is overloaded. Apply less pressure on
the machine.
● If the overload indicator (10) lights red,
the machine is fully overloaded. The machine
will be switched off.
Dust extraction (fig. f)
Only use the machine when it is connected to a
vacuum device which is approved for stone dust.
The vacuum device must be suitable for the
material to be worked. Use a special vacuum
device when working with toxic materials or
where toxic dust is produced.
- Never use a household vacuum cleaner. The
use of a household vacuum cleaner can easily
damage both your health and the vacuum
cleaner.
- Always use the dust extraction adapter.
- Make sure that the hose of the vacuum device
is securely connected to the dust extraction
adapter.
- If the vacuum device breaks down, stop work
immediately, switch off the machine, remove
the mains plug from the mains, and try to solve
the problem.
● Insert the dust extraction adapter (25) into the
dust extraction connection (13).
● Tighten the dust extraction adapter (25) by
turning it clockwise until it locks into place.
● Connect the hose of a vacuum device to the
dust extraction adapter (25).
Hints for optimum use
● Draw lines to define the direction in which to
guide the cutting discs.
● Hold the machine with both hands.
● Set the slot width.
● Set the depth stop.
● Take one of the follwing steps:
- Lower the machine into the wall and set the
slot depth (recommended). The machine is
placed against the wall and the cutting discs
lower into the wall in order to set the slot depth
more accurately.
- Set the slot depth and lower the machine into
the wall.
● Place the machine with the wheels on the wall.
Make sure that the cutting discs align with the
drawn lines on the wall.
● Set the slot depth.
● Switch on the machine.
● Wait until the machine has reached full speed.
● Slowly move the machine along the pre-drawn
lines, firmly pressing the wheels against the
wall.
● Do not apply too much pressure on the
machine. Let the machine do the work.
● Switch off the machine and wait for the
machine to come to a complete standstill
before putting the machine down.

CLEAning AnD MAinTEnAnCE

Before cleaning and maintenance,
always switch off the machine and
remove the mains plug from the mains.
● Regularly clean the housing with a soft cloth.
● Keep the ventilation slots free from dust and
dirt. If necessary, use a soft, moist cloth to
remove dust and dirt from the ventilation slots.
● Regularly clean the cutting discs to avoid
inaccuracies during use.
Checking and replacing the carbon brushes
(fig. A)
The carbon brushes must be checked regularly. If
the carbon brushes are worn, the machine will
start to run unevenly.
Only use the correct type of carbon
brushes.
9