Marta MT-1120 Bedienungsanleitung Seite 12

Switch-on the steam control, setting steam control switch
Press the steam button
CAUTION: Hold the steam button pressing not more than 5 seconds to avoid hot liquid leakage.
CLEANING
Before cleaning the steam iron ensure it is unplugged from the power supply and has completely cooled down.
Clean the exterior with a damp cloth and wipe dry.
Do not use abrasive cleaners.
SELF-CLEANING (for MT-1120/MT-1129)
It is important to apply the self-cleaning function at least every two weeks to remove impurities, etc.
The harder the water the more the iron should be self-cleaned.
-
- Stand the iron on its rear side.
- Set the maximum temperature by thermoregulator and turn Steam control switch for Self-clean
- Insert the main plug into the wall socket.
- Allow the iron to heat up until the light indicator is off.
- Hold the iron horizontally over the sink .
Boiling water and steam will now be ejected from the holes in the soleplate. Impurities are washed with it. Move the iron forwards and backwards while this happened.
Repeat self-cleaning if you notice that much impurity or others has been washed out.
Move the iron over a (preferably) old piece of cloth. This to ensure that the soleplate will be dry during storage.
Unplug and allow the iron to cool down before storing it.
Make sure that the soleplate is completely dry before storing it.
STORAGE
Unplug the steam iron from the power supply and allow cooling down completely.
Empty the water tank after each use, and then wrap the cord around the heel rest.
To protect the soleplate, place the steam iron in an upright position on its heel rest.
SPECIFICATION
Model Power supply
MT-1129 220 240 V, 50 Hz
MT-1120 220 240 V, 50 Hz
on when the water reservoir has become empty.
Power, W Soleplate
1600 Ceramic
1600 Stainless steel
Net / Gross Gift box dimension (L x W x
Weight, kg H),mm
0,68 / 0,87 257 107 130
0,68 / 0,87 257 107 130
12
Functions/ features
3 modes: spray, steam, dry
ironing. Self-clean.
3 modes: spray, steam, dry