Bohr Settings; Drilling Of Dowel Holes With And Without Depth Stop - HOLZMANN-MASCHINEN LKM 1080 Betriebsanleitung

14.2.4 Bohr settings

Drill can be used with drill chuck diameter up to
tool is tightened with an Allen key 6mm. See
The workpiece is secured to the work table by means of the hold-down (10) and the
Excenterspanner.
The movement of the table in the horizontal plane effected by the operating lever (1). The
desired height of the table is accomplished by means of the hand wheel (8). The setting can be
read on the height scale.
The offset distances in the horizontal plane be limited before the operation by slidable lengthwise.
After adjustment tighten!
depth stop

14.2.5 Drilling of dowel holes with and without depth stop

Drilling in its central position fix stops by pushing together the two long.

For a blind hole to adjust the depth gauge to the desired

level.
Loosen the locking lever (2) the fixing pin.

Adjust the height by turning to the desired drilling

distance. 16 – 20 – 22 – 25mm.
Lock the locking pin firmly.

Secure the workpiece, set the LBM 290K according to

14.2.4
Turn the machine on and slowly press the control lever (2) forward until the depth stop strikes

or the workpiece is completely pierced without depth stop.
Convince yourself before each drilling operation that the fixing
pin with the locking lever (2) is fully engaged in the
corresponding opening.
ATTENTION! The workpiece does not hold to the point of
penetration of the drill!
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
LANGLOCHBOHRMASCHINE / MORTISING MACHINE LBM 290K / LBM 290KAL
20 mm on the drill spindle of the machine. The
14.2.7 tool change.
Longitudinal end stops
OPERATION
grid
Fixing pin
Seite 23