• The supplied plug must not be changed.
• If the plug does not fit or is defective, only a qualified electrical engineer may modify or
replace this plug!
• A damaged cable must be replaced immediately!
• Check whether the supply voltage and the current frequency as marked on the rating plate. It
is a deviation from the value of the supply voltage of ± 5% are permissible (eg: a machine
with a working voltage of 380V can work in the voltage range of 370 to 400V)
14
OPERATION
14.1.1 modes
Long-hole drilling
Dowel drilling using the dowel spacing grid.
All conversion work if power is off !!
14.2
Operation
14.2.1 Engine start / stop
If you want to press the ON OFF switch, the combined EMERGENCY
STOP switch must be in the open state.
-
To start, press the green button ˝I˝
To stop, press the red button ˝O˝
-
INFO: In the closed state of the main switch can be operated as an
EMERGENCY STOP switch
14.2.2 Direction of rotation switch
The direction of rotation can be switched to the desired direction of rotation
with the switch.
14.2.3 EMERGENCY STOP switch
When operating the machine stops immediately.
To release this is easily pushed up and, if necessary tighten something.
HOLZMANN MASCHINEN GmbH
www.holzmann-maschinen.at
LANGLOCHBOHRMASCHINE / MORTISING MACHINE LBM 290K / LBM 290KAL
OPERATION
Seite 22