AEG LF 650 Gebrauchsanleitung Seite 6

Joining of
workpieces
Cutting grooves
in thin boards
Sawdust ejector
Exchanging the
blades
ENGLISH
1.
Apply glue to the grooves.
2.
Insert a biscuit dowel.
3.
Put together the workpieces and fix them with clamps, tightening straps, or similar.
The biscuit dowels well up due to the wetness of the glue, and the joint is additionally
strengthened.
When cutting thin boards (thickness of
material less than 16 mm) a thin piece of
wood must be placed under the swivel
fence, otherwise the groove is cut too close
to the surface of the board.
The following devices can be connected to
the sawdust ejector:
suction hose
(via suction nozzle
AEG CleanLine System
(via suction nozzle
suction nozzle
by–pass nozzle
We recommend the AEG NTE 1100
electronic wet–and–dry vacuum cleaner,
which has a socket to which this machine
can be connected directly. As soon as the
saw is switched on, the wet–and–dry
vacuum cleaner switches itself on
automatically.
1.
Loosen the four screws and remove the
cover plate.
2.
Depress the spindle lock and remove the
flange with aid of a pin–type face spanner.
Remove the blade.
3.
To insert a blade proceed in reverse order.
When inserting the blade, take care that the
arrows on the blade and on the base plate
conform.
6
)
)
1 2 3 4
LF 650