AEG LF 650 Gebrauchsanleitung Seite 5

Marking the
groove
distances
Cutting grooves
ENGLISH
Place the two boards to be joined on top of
each other (flush), fix them with
screw–clamps and mark the center of the
grooves. The distance between the grooves
should be 10–15 cm. Smaller workpieces
do not have to be marked.
Depending on the width of the boards the
machine can be positioned in different
ways.
Wide boards:
Position the machine to the workpiece such
that the base plate middle marking is facing
the board marking.
Narrow boards:
Position the machine with the outer edge of
the base plate to the edge of the workpiece.
Very narrow boards:
Position the machine with the outer marking
of the base plate to the edge of the
workpiece.
This setting can also be used for the case
that the biscuit joint is located close to the
edge.
1.
Position the machine as described above.
2.
Switch the machine on.
3.
Push the machine forward and plunge the
blade slowly into the material as far as it will
go. Hold the machine with both hands.
Slightly release the pressure, the motor part
is pulled back to the original position by
resilience.
4.
Switch the machine off.
5
1 0
- 1
5
c m
4 -
6
c m
20
LF 650
20
20
20