AEG LF 650 Gebrauchsanleitung Seite 4

Choosing the
sizes of the
biscuit dowels
Setting of routing
depth
Setting the
cutting angle
Setting the
machine to the
thickness of the
board
ENGLISH
The size of the biscuit dowels to be used depends on the thickness of the material.
Always use biscuit dowels of the biggest possible size to ensure a solid joint. If the
working material is thicker than 25 mm, use 2 biscuit dowels on top of each other.
Thickness of Material
8–12 mm
12–15 mm
> 15 mm
Set the cutting depth with the adjustment
knob according to the chosen biscuit dowel
to be used.
Size Biscuit Dowel Cutting Depth
No. 0 0
No.10 10
No.20 20
Simplex S
Duplex D
maximum Max
Unlock the left clamping lever, set the
swivel fence with aid of the scale to the
required angle (e.g. for mitre joints), and
re–fasten the clamping lever.
The angles most frequently used (22.5
o o
45 , 67.5 ) can be quickly adjusted with
aid of notched stages.
Should the locked clamping lever be in the
way when working with the tool, fasten it in
a different position by pulling it out without
unlocking it.
To be able to cut the groove for the biscuit
dowel centrically, the joiner must be pre–set
to the board thickness. Unlock the right
clamping lever, set the swivel fence with aid
of the scale to the required board thickness,
and re–fasten the clamping lever.
The values on the scale are only applicable
when the push–on plate is fitted.
Should the locked clamping lever be in the
way when working with the tool, fasten it in
a different position by pulling it out without
unlocking it.
Three board thicknesses can be pre–set at
the depth guide. It is factory pre–set to 16,
19, and 25 mm.
4
Size of Biscuit Dowel
0
10
20
8.0 mm
10.0 mm
12.3 mm
13.0 mm
14.7 mm
19.0 mm
o
,
Measures
47x15x4
53x19x4
56x23x4
90
90
0
0
10
1 2 /
20
1
10
1 2 /
20
1
20
LF 650