Specific Telescopic Pole Connector/Specific Pole (Not Included) Assembly; Pool Preparation; Operation - Vektro DELUXE Bedienungsanleitung

Specific telescopic pole connector/specific pole (not included) assembly

only)
Align and insert the pole connector into the post as shown. Press on the internal wishbone
clip (preinstalled inside the specific telescopic pole) to retract its side pins. Slide the
specific telescopic pole into the specific pole connector until it's locked in place by the side
pins and holes.

Pool Preparation

- If the liner is brittle, damaged, or wrinkled, contact a qualified professional to perform the
necessary repairs or perform a liner replacement prior to using the pool vacuum.
- If you are using a saltwater pool, make sure all salt are dissolved before placing the pool
vacuum into the water.

OPERATION

1) Bring your pool vacuum to the side of your pool. Turn the switching knob clockwise
until it clicks to expose the water sensors. The light at the top will turn blue.
Immerse the pool vacuum into water, the light turns immediately to green and the
impeller will start to turn after 4-5 seconds.
Light Color
Blue Power On
(ready for operation)
Blue – Flash Battery level is running low
Green In operation
Green -Flash Battery level is running low.
Green light Off Battery depleted
(need to be recharged)
Red Impeller stops
(impeller clogged).
(for Australia/New Zealand
13