Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
The terms "white paper" and "white film" are synonymous references and used interchangeably in
this manual.
File Transfer via FTP and LPR
Different users who share a user name when transferring files to the imager may cause
•
unpredictable and erroneous printed output. The imager associates information with the user
name. Each user should have a unique user name when connecting to the imager via FTP and
LPR.
Color Management
Image settings—including gamma, contrast, Dmax, saturation, and MCM™ (Medical Color
•
Matching™)—are intended to compensate for differences that may occur between image
acquisition and image printing. These filters allow you to accurately render the final printed
image. You should use care when applying these filters to avoid over compensation.
The Default User Settings set at the control panel will potentially affect prints made by all users.
•
Use caution when changing the default settings.
Image Scaling
Scaling an image will filter the original image data and add or remove information, which may
•
affect the accuracy of the final printed image. The amount of information added or removed will
also vary with the magnitude of the scale factor applied. This can also affect the accuracy of the
final printed image. You should be aware of the properties and limitations of each scaling
algorithm and select the appropriate algorithm for the task.
Hardware Variations
Components used in the imager may vary, causing differences in image quality. The thermal
•
process of producing a print utilizes many components that are calibrated to provide
consistency between imagers. There are subtle differences between imagers that can cause print
variations. These differences usually apply to thermal print head calibration. Other factors such
as age, usage, heat, mechanical wear, and shipping can affect image color and quality.
The type of media used to install software updates and to backup imager configuration settings
•
depends on hardware variations. If the imager has a built-in Zip drive, installations and backups
are performed using 100-MB Zip disks. If the imager does not have a built-in Zip drive, USB flash
drives are used with the USB ports on the rear panel. Throughout this manual, Zip disks and USB
flash drives are referred to as
being performed.
NOTE: If the imager has both a Zip drive and a USB port, always use the Zip disk to install software
and save configuration settings.
Disposal Requirements
Disposal of this product and consumables shall be in accordance with all applicable laws and
regulations in effect at the locality at the time of disposal.
European Disposal Requirements
Codonics imagers and electronic accessory devices are not to be discarded or recycled; rather they
are to be returned to the manufacturer. Contact Codonics directly or by the link provided for the
latest information concerning:
Identification of the country-specific Importer/Distributor/Producer
•
Product return and treatment of our electronic products
•
installation media
or
backup media
, depending on the operation
Werbung
Inhaltsverzeichnis
