On/Off Switch - Black & Decker KS990E Handbuch

Electrical safety
This tool is double insulated; therefore no earth wire
is required. Always check that the power supply
corresponds to the voltage on the rating plate.
Additional safety instructions for hand-held saws
Always use the appropriate type of saw blade for the
workpiece material and type of cut.
Only use saw blades in perfect condition.
Always switch the tool off and wait for the saw blade to
come to a complete standstill before putting the tool down.
Keep your hands well clear of the saw blade while working.
Whenever possible, use clamps or a vice to secure the
workpiece.
Do not use the tool while in a tree, on a ladder or on any
other unstable surface.
When cutting branches be aware of where the branch will
fall.
Hearing protection should be worn when using this
tool.
Features
This tool includes some or all of the following features.

1. On/off switch

2. Lock-off button
3. Speed control wheel
4. Blade holder
5. Blade changing button
6. Shoe
7. Shoe locking button
In addition, this tool is supplied with some or all of the
following accessories (fig. A):
Accessory
8. 24 tpi recip blade
9. 6 tpi curved teeth
10. 6 tpi straight teeth
11. Ground set recip blade
12. Circle cutter / edge guide
13. 18 tpi wavy, milled blade
14. 6 tpi set, milled blade
15. 10 tpi set, milled blade
16. 10 tpi scroll, milled set
Note: tpi = teeth per inch
Warning! When using the dry wall blade to cut into walls or ceilings, make sure to check for the location of wiring and pipes
near the cutting area.
Assembly
Warning! Before attempting any of the following operations,
make sure that the tool is switched off and unplugged and
that the saw blade has stopped.
Fitting the saw blade (fig. B)
Hold the saw blade securely. If the saw blade is fitted
with a tooth protector, leave it attached while fitting the
blade.
Depress the blade changing button (5).
Insert the shank of the saw blade into the blade holder (4)
as far as it will go.
Release the blade changing button.
Remove the tooth protector, if fitted.
Note: This tool has been designed to allow the saw blades to
be fitted with the teeth facing forward or backward.
Removing and fitting the shoe (fig. C)
The shoe can be removed for cleaning the tool or for fitting the
circle and edge guide.
Hold the tool as shown.
Depress the shoe locking button (7) and slide the shoe (6)
away from the tool.
Release the shoe locking button.
To fit the shoe:
Depress the shoe locking button and slide the shoe into
the slots.
Release the shoe locking button and make sure that the
shoe is securely attached to the tool.
Fitting the circle cutter / edge guide (fig. B, C, D & E)
Remove the saw blade from the blade holder (4).
Remove the shoe (6).
Recommended application and use
Cutting metal
Fast cutting of wood and plastic
Dry wall (plaster board)
Pruning
Cutting metal
Fast cutting of wood
Cutting plastic
Scroll cutting
ENGLISH
Sawblade orientatien
Teeth facing back
Teeth facing back
Teeth facing back
Teeth facing back
Teeth facing forward
Teeth facing forward
Teeth facing forward
Teeth facing forward
5