Klarstein VINAMOUR 40 DUO Bedienungsanleitung Seite 18

EN
18
Before switching on
• Make sure that it has been installed by a suitably qualified person, as per the
information contained in the installation instructions.
• After delivery, wait for 24 hours before connecting the appliance to your mains
supply. This will allow any refrigerant gasses that may have been disturbed during
the transportation process to settle.
• The outside of the appliance and the removable accessories contained within it,
should be cleaned with a solution of liquid detergent and water.
• The interior of the appliance should be cleaned with a solution of sodium
bicarbonate dissolved in lukewarm water. The interior and accessories should be
thoroughly dried, after the cleaning process has been completed.
• There can be an odour when you first switch on the appliance. It will lessen as the
appliance starts to cool.
During first use
Important: When you use the wine cooler for the first time or restart the appliance
after it has been turned off for a long time, there could be a few degrees variance
between the temperature you select and the one indicated on the LED display. This is
normal and it is due to the length of activation time. Once the wine cooler has been
running for a few hours everything will be back to normal.
• When you first switch on the appliance, the compressor will run continuously until
the wine cooler reaches a cool enough temperature.
• During this period of time, you should try not to open the door frequently or place
bottles inside of the appliance.
• If the unit is switched off or unplugged, you must allow at least 5 minutes before
restarting the appliance or reconnecting it to your mains supply.
Switching on the appliance and setting the temperature
• To switch the appliance on, press the Power button and hold 5 seconds, turn the
appliance off again, press and hold the Power button for 5 seconds.
• When you press the TEMPERATURE SET BUTTONS [+] or [-] for the first time, the
LED display will indicate the factory preset temperature.
• Press the TEMPERATURE SET BUTTONS [+] or [-] once. The display will increase or
descrease 1°C or 1°F until the temperature you want.
• To see the set temperature at any time, touch the buttons UP BUTTON [+] or
DOWN BOTTON [-] set temperatures temporarily flash on the display for about 5
seconds.
Important: When the temperature is changed, the compressor works harder to
reach the required tem- perature. And the compressor will work slowly and even stop
working when the set temperature is reached.