Installing/Removing Main Memory - Fujitsu Siemens Computers D2344 Handbuch

Procedure
The processor socket ist covered with a protective cap to protect the spring
contacts In a warranty case the mainboard can only be taken back by Fujitsu
Siemens Computers with the protective cap secured!
b
Please note that, depending on the heat sink used, different heat sink
mounts are required on the mainboard.
► Depending on the configuration variant, you must pull a protective foil off the heat sink
or coat the heat sink with heat conducting paste before fitting it.
► Secure the heat sink - depending on the model - with four screws or push it into the mounts.

Installing/removing main memory

Disconnect the system completely from the mains voltage before performing any of the
tasks described below. Details are contained in your systems' operating manual.
Technical data
Technology DDR2 533 / 667 / 800 unbuffered DIMM modules 240-Pin; 1.8 V; 64 Bit, no ECC
Total Size 128 Mbytes to 8 Gbytes DDR2
Module size 128, 256, 512, 1024 or 2048 Mbytes per module
A26361-D2344-Z110-1-7419, Edition 1
b
a
Brief description of the mainboard
► Remove the heat sink.
► Press down on the lever and unhook it.
► Fold up the frame.
► Hold the processor between your thumb
and index finger and insert it into the socket
(b) so that the marking of the processor is
aligned with the marking on the socket (a).
► Press the lever downward until it is
hooked in again.
► Remove the protective cap and keep it.
English - 3