Inklang AYERS Three Bedienungsanleitung Seite 17

english - EN 6
1. Place the loudspeaker in its final position and place two knurled spikes and plates on the left and right of the loudspeaker
2. Carefully tilt the loudspeaker to the left, screw the spikes into the thread as far as they will go and carefully put it down again
3. Repeat that on the right side of the speaker
4. Now carefully tilt the loudspeaker again and place the plate in the center under the spike at the back and front and carefully lower the loudspeaker until it
sinks neatly into the plate or the tip of the spike is exactly immersed in the holder of the plate
5. Make sure that the loudspeaker is in its final position and does not tip over. Compensate for this by unscrewing individual spikes.
CAUTION: Careless handling of the spikes can lead to injuries.
UNPACKING
Use of the spikes
SET UP CONNECT BURN IN MAINTENANCE
!
WARRANTY