Trix MINITRIX 15385 Bedienungsanleitung Seite 6

Safety Notes
• Analog 14 volts DC, digital 19 volts AC.
• Do not expose the model to direct sunlight, extreme changes
in temperature, or high humidity.
• The wire used for feeder connections to the track may be a
maximum of 2 meters / 78 inches long.
• WARNING! Sharp edges and points required for operation.
Important Notes
• The operating instructions and the packaging are a compo-
nent part of the product and must therefore be kept as well as
transferred along with the product to others.
• Please see your authorized Trix dealer for repairs or spare
parts.
• The warranty card included with this product specifies the
warranty conditions.
• Disposing: www.maerklin.com/en/imprint.html
• The LEDs in this item correspond to Laser Class 1 according
to Standard EN 60825-1.
• The coupling drawbars included with the models can be used
for a prototypical car spacing.
General Note to Avoid Electromagnetic Interference: A
permanent, flawless wheel-rail contact is required in order to
guarantee operation for which a model is designed. Do not make
any changes to current-conducting parts.
6
Functions
• Built-in electronic circuit for optional operation with
a conventional DC train controller (max. ±14 volts),
Trix Systems, Trix Selectrix (Sx) or digital systems adhering to
the NMRA standards.
• Automatic system recognition between digital and analog
operation.
• No automatic system recognition between the digital sys-
tems.
Headlights
Notes on digital operation
• When operating in a digital system for the first time (Sx1 or
DCC), the decoder must be set to this digital system. To do
this, the decoder must be programmed once in this digital
system (example: change the address).
• Address set at the factory:
DCC: 3
Sx: 1
• For correct light changeover, we recommend setting the
function decoder for the car to the address of the locomoti-
veand adjusting the braking delay to the locomotive
(CV 1/4 locomotive = CV 1/4 car).
Sx DCC
F0