S Ettings - SUHNER MACHINING MAX 100 CO Betriebsanleitung

.
Remove the belt. Disassemble the nut and locknut. Di-
sassemble the TOP 0 detection disc. Remove the clam-
ping sleeve from the pulley. Change the pulley. Follow the
procedure in reverse order for reassembly.
Note the correct belt tension!
3.2 s
ettIngs
3.2.1 top 0
settIngs
This detector supplies an information (flank) by rotation.
The angular position of this flank is settled in a random
way in factory.
This TOP 0 is necessary for motor with incremental coder.
In case of change of receiving pulley or belt think
of redoing the setting.
3.2.2 a
uthorIZatIon spIndle rotatIon
This sensor indicates if the piston of the jack is in «back»
position and authorizes the putting in rotation of the
spindle.
Never put in rotation the spindle when this sensor
is not in the state «1».
3.2.3 c
lamp posItIon
1
2
3
Sensor 1 = Toolholder release sensor.
Sensor 2 = Drawbar in back position, clamped with tool-
holder.
Sensor 3 = Drawbar in back position, clamped without
toolholder.
Setting detection:
Loosening screws M4 of the small metal plate to access
to the detectors. Place the unit in the position to detect
slide-up sensor detect the desired position. Tighten the
detector. Please make sure that when state changes, the
unit detector state (over detection) is also changing. Re-
peat this procedure for each detector.
31