Cleaning And Maintenance - Bestron WINTER WARM ACV2001 Bedienungsanleitung

USE - Location
Place the convector heater on a stable surface in the room to be heated. The heater heats the air flowing
past the appliance. For this reason, the best place for the convector heater is 20 to 25 cm in front of a
window. An air flow is generated by the cooling of air passing the window and the heating of air passing the
convector heater.
WARNING:
• Make sure that air can pass through the heater easily. For this reason the top and bottom of the convector
heater must always remain unobstructed. Never hang clothing, etc., over the convector heater to dry.
The heat produced by the heater could readily result in a fire.
USE
1. Rotate the thermostat dial to "O".
2. Make sure the function dial is set to "0".
3. Insert the plug into the plug socket.
4. Use the function dial to select the desired setting:
Button a = 1250 Watts
Button b = 750 Watts
Button a+b = 2000 Watts
5. Rotate the thermostat dial towards the "MAX" setting. The appliance will turn itself on, a click will be
heard and the On/Off indicator light will be lit. The temperature is increased by turning the thermostat
dial further.
6. Switch on the turbo fan if you wish to distribute the heat through the room quickly. You can also use the
turbo fan to distribute cold air. By only switching on the turbo button.
7. Switch the appliance off after use by turning the function dial to the "0" position and remove the plug from
the wall socket. Set the thermostat dial to the "O" setting again.
To find the ideal thermostat setting, rotate the thermostat dial clockwise as far as possible. Once the room
has reached the desired temperature, slowly rotate the dial anticlockwise until a click is heard. The appliance
will then turn itself off. The temperature control will ensure that the room remains at the set temperature.
WARNING:
• Never cover the air inlet or the air outlet.
• The thermostat switches off the heating element and the turbo fan once the desired temperature has
been reached.
• The convector heater is fitted with an overheating safeguard. The convector heater will be switched off
automatically if the appliance's internal temperature becomes too high. The overheating safeguard will
be disabled once the appliance has cooled down sufficiently and the convector heater can then be used
again.

CLEANING AND MAINTENANCE

• Remove the plug from the plug socket and allow the convector heater to cool down.
• Clean the convector heater with a damp cloth. If necessary, use a little washing-up liquid to clean the
convector heater. Make sure no moisture enters the convector heater.
• Dry the appliance thoroughly after cleaning.
• Never immerse the appliance in water.
WARNING:
• Never use corrosive or scouring cleaning agents or sharp objects (such as knives or hard brushes) to
clean the appliance.
25
EN