Restore Factory Default - Reflexion DVD1017 Bedienungsanleitung

Restore Factory Default:

The menu item deletes all settings made and restores the default
settings. Before the execution, a password query takes place.
1. Enter the password
2. Confirm the confirmation prompt with the "ENTER" key or
the "EXIT" key to cancel.
3. The device then starts with the initial installation.
Information:
The menu item displays model, hardware and software information.
Software Update:
Perform a software update using an update file via USB cable. When
available.
USB-MENU
To access the USB menu, press the "SETUP" button and select the
menu item USB with the "◄ / ►" buttons.
Multimedia:
Use the "▲ / ▼" buttons to navigate to the
1.
"MULTIMEDIA" menu item.
2. Confirm the entry with the "ENTER" key.
3. The device enters USB mode.
4. Now you can access data that exists on the USB stick.
Note:
The menu item can also be accessed via the "SOURCE" button.
.
ERROR SULUTION
Problem Possible reasons
Electricity is not
No picture
The power switch is off
DVB-T cable / antenna
Screen shows no
is not connected
signal
Sound is mute
No sound from the
Wrong audio format
speaker
Only sound, no
Wrong setting radio
picture
program selected
The batteries are empty
Remote control does
Remote control not show to the device
does not respond
The device is too far
Suddenly no
The received signal is
picture anymore
(mosaic education)
What should I do
Connect to the power
connected adapter
Press the power
button
DVB-T cable /
antenna is not
connected
Disable mute function
/ Select a different
sound format
Press the button "TV /
Radio"
Replace battery
Hold remote control to
the device
Move closer to the
away device with the remote
control
Amplify the signal.
Other position of the
too weak
antenna