Pipe Locating Los /Loe 200 - HEYLO LSK 200 Bedienungsanleitung

2. Pipe locating LOS /LOE 200

Application
The system consists of a transmitter and a receiver and allows exact locating of pipes
as well as their routing in hollow spaces or under screed. The pipe depths can be
determined as well. The device is ideally suited for pipes of indoor installations. Install
the pipe locating system to establish an electrical circuit. Only metal pipes can be
detected.
Battery 9V
Level
Receiver front panel
No Connecting Charge rechargeable
channel batteries
Signal output terminal socket

Sound Maximum
Sound Minimum
Connecting
channel
The transmitter applies a signal to the pipe.
A green LED on the transmitter indicates
correct installation. If a connecting channel
exists, then the receiver can receive the
signal, whereby a minimum signal can be
detected directly above the pipe. On the left
and right of the pipe the signal is very loud
(sound maximum). If the device is tilted by
45 degrees over the pipe center, and pulled
away from the pipe route, then the
difference to the new sound minimum
indicates the pipe depth. This enables pipe
locating with a few centimeters accuracy.
Standard equipment in the case:
Transmitter: with integrated functional test,
2 cables with clamps, charger
Receiver: with antenna, integrated
loudspeaker, level indicator and battery
control
Transmitter back panel
Charging socket
15
On/Off
EN