Tens-Therapy - RIKTA ESMIL 2A Bedienungsanleitung

38
On expiry of the set time, a triple "beep" will sound: the treatment of the zone
is finished.
You can stop treatment at any time by pressing
If you press this button again, the treatment will start again at the
previously set frequency and time values.
If it is necessary to carry out TENS-therapy, the voltage level on the
electrodes is set again.

TENS-THERAPY

After starting the treatment and before its completion, you can start TENS-
therapy at any time with a short press of the button
Only when the electrodes are in contact with patient's skin, the
electrodes will be supplied with the voltage.
Then, briefly press the buttons
TENS intensity (electrodes voltage).
TENS intensity is adjusted by personal sensations of a patient (see the
Methodical manual):
– minimum TENS intensity (Min.): the patient feels a subtle tingling of the
skin under the electrodes;
– optimal TENS intensity (Optim.): the patient feels a nonirritating tingling
of the skin under the electrodes, when scanning, a specific sound is
EN
heard under the electrodes;
– maximum TENS intensity (Max.): the patient feels a distinct tingling and
vibration, a specific sound is heard under electrodes, there is resistance
to movement of electrodes on skin.
TENS indicator [7] blinks during the TENS-therapy.
The blinking frequency of the TENS indicator depends on electrodes voltage:
the higher the voltage level is, the higher the blinking frequency is.
(TENS +) and (TENS –) to adjust the
Operating manual
button.
.