Remote Control Battery Replacement; First Time Installation; Remote Control Preparation - Sharp HT-SB140 Benutzerhandbuch

Remote control
1. – Switch the unit between ON and
STANDBY mode.
2. – Select the Bluetooth mode.
Press and hold to activate the
pairing function in Bluetooth mode
or disconnect the existing paired
Bluetooth device.
3. – Select the play function.
4. VOL +/- – Increase/decrease the
volume level.
5. / – Skip to previous/next track
in Bluetooth mode.
6. – Play/pause/resume playback in
Bluetooth mode.
7. – (MUTE) Mute or resume the
sound.
8. BASS +/- – Adjust bass level.
9. TRE +/- – Adjust treble level.
10. EQ – Select a preset sound mode.

First time installation

Remote control preparation

The provided Remote Control allows the
unit to be operated from a distance.
• Even if the Remote Control is operated
within the eff ective range 6m, remote
control operation may be impossible
if there are any obstacles between the
unit and the remote control.
• If the Remote Control is operated near
other products which generate infrared
rays, or if other remote control devices
using infra-red rays are used near the
unit, it may operate incorrectly. Conver-
sely, the other products may operate
incorrectly.
Remote control battery
replacement
1. Press and slide the back cover to
open the battery compartment of the
remote control.
2. Insert two AAA size batteries
(included). Make sure the (+) and (–)
ends of the batteries match the (+)
and (–) ends indicated in the battery
compartment.
3. Close the battery compartment cover.
EN EN