MBO TG 1100 Bedienungsanleitung Seite 12

TG 1100 GB
2
Additional
safety measure
Barbecue Stand
See "Barbecue Des-
cription" illustration.
www.MBOservice.net
Downloaded from www.Manualslib.com
25.01.2003 12:53 Uhr
INTRODUCTION
9. Do not switch on the barbecue unless the reflector is covered
with water.
10. Always remove the plug from the socket after use and
before cleaning. The same applies if any problems occur
during operation
11. Check the equipment for signs of damage at regular inter-
vals.
12. Never use electrical equipment that is damaged or has a
damaged power cable. All repairs must be carried out by a
service centre or an authorised specialist dealer in order to
avoid potential hazards.
13. Never use charcoal or similar combustible fuels with this
equipment.
14. The installation of a fault current protection device (RCD) is
recommended for additional protection. Please consult your
electrical installer.
15. Please ensure that the equipment is always supervised
during operation.
16. If the equipment is given to third parties, please also provide
the operating instructions.
Please ensure that the thermostat housing is properly in-
serted into the barbecue tray. All grilling must take place
in the barbecue tray: safety switch!
The barbecue is equipped with a safety switch. As soon as the
heating element and the thermostat housing are removed from
the barbecue tray, the heating spiral automatically switches off.
Please note that the element is still extremely hot immediately
after operation and must not be touched.
To make the barbecue easier to operate, the equipment is sup-
plied with a stand and a bottom shelf (for cooking implements,
for example). Attach the 4 legs to the stand by inserting the
screws from the front through the opening in the metal tube
and the shelf behind it and securing them from behind using
the nuts.
The barbecue can now attached to the stand using the four
locating elements.
manuals search engine
Seite 2