Installation - IKEA VINTERKALL AA-2230791-3 Bedienungsanleitung

ENGLISH
• Before maintenance, deactivate the
appliance and disconnect the mains plug
from the mains socket.
• This appliance contains hydrocarbons in the
cooling unit. Only a qualified person can do
the maintenance and the recharging of the
unit.
• Regularly examine the drain of the
appliance and if necessary, clean it. If the
drain is blocked, defrosted water collects in
the bottom of the appliance.
Service
• To repair the appliance contact the
Authorised Service Centre listed at the end
of this manual.
• Use original spare parts only.

Installation

Warning! Refer to Safety chapters.
Positioning
• Follow the separate Assembly Instructions
to install this appliance.
• This appliance should be installed in a dry,
well ventilated indoor where the ambient
temperature corresponds to the climate
class indicated on the rating plate of the
appliance:
Climate class Ambient temperature
SN +10°C to +32°C
N +16°C to +32°C
ST +16°C to +38°C
T +16°C to +43°C
"SN" indicates that this refrigerating
-
appliance is intended to be used at ambient
temperatures ranging from 10 °C to 32 °C.
"N" indicates that this refrigerating
-
appliance is intended to be used at ambient
temperatures ranging from 16 °C to 32 °C.
"ST" indicates that this refrigerating
-
appliance is intended to be used at ambient
temperatures ranging from 16 °C to 38 °C.
"T" indicates that this refrigerating
-
appliance is intended to be used at ambient
temperatures ranging from 16 °C to 43 °C.
Disposal
Warning! Risk of injury or suffocation.
• Disconnect the appliance from the mains
supply.
• Cut off the mains cable and discard it.
• Remove the door to prevent children and
pets to be closed inside of the appliance.
• The refrigerant circuit and the insulation
materials of this appliance are ozone-
friendly.
• The insulation foam contains flammable
gas. Contact your municipal authority for
information on how to discard the appliance
correctly.
• Do not cause damage to the part of the
cooling unit that is near the heat exchanger.
Some functional problems might occur
for some types of models when operating
outside of that range. The correct
operation can only be guaranteed within
the specified temperature range.
If you have any doubts regarding
installation, please turn to the vendor, to
our customer service or to the nearest
Authorised Service Centre.
Location
• To ensure best performance, install the
appliance well away from sources of heat
such as radiators, boilers, direct sunlight
etc. Make sure that air can circulate freely
around the back of the cabinet.
• Install the supplied distance holder to allow
enough space between the refrigerator and
the wall (refer to the separate Assembly
Instructions).
If the installation of the supplied distance
holder is not possible, leave a space of at
least 10 cm between the appliance and the
wall, and at least 30 cm between the top of
the appliance and the ceiling.
• Leave enough space to access and open the
door easily (W x D ≥ 1400 × 1000 mm).
9