Default Settings; Before Configuration - Atlantis Land A02-RA141-W54 Schnellstartanleitung

ENGLISH
switched on the Wireless Router ADSL2+ the product will
carry on immediately a diagnosis (60 seconds). Finished this
the Led PWR, SYS (eventually even the Led LAN, if
connected to PCs) will be fixed green (WLAN is blinking
when wireless module is loaded) . The Led ADSL, if suitably
connected, at first will be flashing and then it will remain
fixed. You have to read Note (into section 1.8) in order to
solve this problem

1.5 Default Settings

The WebShare Wireless Router ADSL2+ can be configured
with your Web browser. The web browser is included as a
standard application in following operation systems, UNIX,
Linux, Mac OS, Windows 95/98/NT/2000/Me, etc. The
product provides a very easy and user-friendly interface for
configuration.

Before Configuration

This section describes the configuration required by LAN-
attached PCs that communicate with the WebShare
Wireless Router ADSL2+, either to configure the device, or
for network access. These PCs must have an Ethernet
interface installed properly, be connected to the
WebShare Wireless Router ADSL2+ either directly or
through an external repeater hub, and have TCP/IP installed
and configured to obtain an IP address through a DHCP
server or a fixed IP address that must be in the same subnet
of the Wireless ADSL Router. The default IP address of the
WebShare Wireless Router ADSL2+ is 192.168.1.254 and
subnet mask is 255.255.255.0. The best and easy way is to
configure the PC (client DHCP) to get an IP address from
the WebShare Wireless Router ADSL2+.
28