Button Description; How To Install - Wisenet SEP-102CRW Bedienungsanleitung

Button Description

Reset button: Press the reset button for at least 3 seconds to reset the camera.
`
Power switch: Turn ON/OFF the camera.
`
Pair button: Pair camera(s) to monitor.
`

How to install

CAUTION: If you are using this system to watch a young child, please do not place the camera within the
child's reach.
Before you install the camera, carefully plan where and how it will be positioned, and where you will route the
cable that connects the camera to the power adapter.
Before permanently installing the camera, verify the camera's performance. Check the monitor's image
quality when positioning the camera in the same location/position of where it will be installed, and where the
monitor will be placed when being used.
Installation Warnings
Aim the camera(s) for optimal viewing: Select a camera location that provides a clear view of the area you
want to monitor, which is free from dust and is not in direct line-of-sight to a strong light source or direct
sunlight.
Avoid installing the camera where there are thick walls or obstructions between the camera and the monitor.
STRANGULATION HAZARD - Keep cord out of child's reach. NEVER place camera or cords within 3 feet of
crib or playpen. Never use extension cords with AC Adapters. Only use the AC Adapters provided.
1. Carefully unpack the camera.
If you are installing cameras that did not come with the system, please
see the camera pairing section in this manual for details on installation.
2. Mount the camera to the wall.
Mark the position of the screw hole on the wall, then drill a hole and
insert a screw. Then firmly attach the camera to the wall by placing the
stand over the installed screw and pushing the base downwards.
To install on a concrete wall, drill a hole and use the plastic anchor to so the camera is
n
`
in a fixed position.
The camera can also be placed on a flat surface, such as a table or shelf, and no mounting
`
hardware is required.
3. Adjust the viewing angle of the camera.
Pan/tilt using the keypad on the monitor to adjust the viewing angle
of the camera.
Adjusting the camera with excessive force may damage the unit.
n
`
English · 7