Preparation; Use - Imetec S0101 Bedienungsanleitung

• Unpack the product.
• Check that it is intact and not damaged.
EN
• Connect the product to the domestic mains.
WARNING! This appliance is not to be used if it has been
dropped or if there are visible signs of damage.
• For fan operation, move the power switch (8) to the cool air position and adjust the ambient thermostat
(2) to the maximum temperature.
• For gradual heating, move the power switch (8) to the position with ECO (Type S0101 only) or to the
hot air position II (Type S0102 only) and adjust the ambient thermostat (2) to the required temperature.
• For quick heating, move the power switch (8) to the rapid heating position III and set the ambient
thermostat (2) on the required temperature.
• To switch the appliance off, turn the power switch (8) to off
Minimum temperature/ Anti-freeze function (where available)
• This function assures maintaining the room temperature at around +5°C. The fan heater turns on
automatically as soon as the temperature falls below this value.
• Adjust the room thermostat (2) to the minimum temperature.
• Turn the power switch (8) to the ECO mode position (Type S0101 only)or the hot air position II (only
Type S0102) to gradually achieve a temperature of +5°C.
• Turn the power switch (8) to the Rapid heat position III to quickly achieve a temperature of +5°C.
Silent function (only Type S0102)
Thanks to the SILENT function it is possible to achieve the best ratio between heat, energy consumption
and silence.
Ionizer function (only Type S0102)
The fan heater with ionizer is equipped with a device that reproduces the natural phenomenon of
ionization. The negative ions generated by the fan heater precipitate the pollutants accentuating the
process of cleaning and revitalizing the air.
Auto shut off function (only Type S0102)
The fan heater is equipped with an automatic shutoff function after 1 hour, 3 hours or 9 hours.
When turned on, the green LEDs of the auto shut-off timer display (7b) will flash in sequence.
Press the START / Timer Selector button (7 a) to set the desired sleep time:
• Press once for 1 h auto shut off timer
• Press twice for 3 h auto shut off timer
• Press 3 times for 9 h auto shut off timer
The relevant selections will light up on the sleep timer display (7b).
When the selected time has elapsed, the fan heater will switch off and the stand by LED (7c) will light
up blue.
To reactivate operation, press START / Timer Selector again as indicated above.
NOTE: when a new usage time is selected, the countdown will restart from zero.
14

PREPARATION

USE