Product Overview - Transmitter - LEGRAND C2G C2G30024 Bedienungsanleitung

HDMI HDBASET + USB-B AND RS232 OVER CAT EXTENDER SINGLE GANG WALL PLATE
TRANSMITTER TO BOX RECEIVER - 4K 60HZ
Product Overview
Front Panel
Transmitter
F P D
RONT ANEL ESCRIPTION
On: Power is applied to the device.
1 Power LED
Off: No power is applied to the device.
On: HDMI input signal is active.
2 HDMI LED
Off: No HDMI signal input.
On: HDBT link is normal.
3 Link LED
Off/Blinking: No HDBT link or link error.
4 HDMI IN Connect to an HDMI source using an HDMI cable.
5 USB Host Connect USB host PC.
Rear Panel
Transmitter
R P D
EAR ANEL ESCRIPTION
6 HDBT OUT Connect to the HDBT receiver via a Cat 5e/6/6a/7 cable.
Connect to a DC 12V power adapter. With one-way PoH
7 DC 12V function supported, the transmitter can be powered by the
receiver.
Connect to a RS232 enabled device for RS232 pass-through or
8 RS232
connect to a PC for upgrading firmware.
Set the function of RS232 port.
Pass-through: The RS232 port is used to commands pass-
RS232 through via HDBT. Users can use API command to upgrade its
9
DIP Switch MCU firmware in this mode.
Update: The RS232 port is used to upgrade Valens firmware of
transmitter and receiver.
2
(us)