Product Overview - LEGRAND C2G C2G30021 Bedienungsanleitung

HDMI HDBaseT + RS232 and IR over Cat Extender Single Gang Wall Plate Transmitter - 4K 60Hz

Product Overview

Front Panel
Transmitter
F P D
RONT ANEL ESCRIPTION
On: Power is applied to the device.
1 Power LED
Off: No power is applied to the device.
On: HDBT link is normal.
2 Link LED
Off/Blinking: No HDBT link or link error.
3 IR Window Receive IR signals.
4 HDMI IN Connect to an HDMI source using an HDMI cable.
Rear Panel
Transmitter
R P D
EAR ANEL
Connect to an HDBT receiver (such as C2G30015 or
5 HDBT OUT
C2G30016) via a Cat 5e/6/6a/7 cable.
Connect to a DC 12V power adapter. The transmitter can
6 DC 12V
be powered by the receiver with PSE module.
Connect to a RS232 enabled device for RS232 pass-
7 RS232
through or connect to a PC for upgrading firmware.
8 IR IN Connect to an IR receiver cable.
Control the function of RS232 port.
Update: RS232 port is used to update firmware.
9 DIP Switch
Pass-through: RS232 port is used to command pass-
through via HDBT port. (default)
2
ESCRIPTION
(us)
(us)