Makita MR002G Betriebsanleitung Seite 9

INSTALLATION AND POWER
SUPPLY
CAUTION:
● Be careful not to pinch your fingers when
opening and closing the battery cover.
● Return the battery compartment locker to the
original position, after installing or removing
battery cartridge. If not, battery cartridge may
accidentally fall out of the radio, causing injury to
you or someone around you.
● Always close and lock the battery compartment
locker before moving the radio.
● Always switch off the radio before installing or
removing the battery cartridge.
● Be careful not to drop or strike the radio. Broken
shell may slash your finger or stab your body.
Damaged radio may exhibit unpredictable behaviour
resulting in fire, explosion or risk of injury.
● Hold the tool and the battery cartridge firmly
when installing or removing battery cartridge.
IMPORTANT:
● Reduced power, distortion, "stuttering sound" or when
both low battery indicator and "POWERFAIL" appear
on the display are all the signs that the main battery
pack needs to be replaced.
● When low battery indicator appears and an "EMPTY"
keeps on flashing is the time to replace the backup
batteries.
● The battery cartridge can't be charged via the
supplied AC power adaptor.
● The battery cartridge is not included as standard
accessories.
Installing or removing slide battery
cartridge (Fig. 2-5)
● To install the battery cartridge, align the tongue on
the battery cartridge with the groove in the housing
and slip it into place. Always insert it all the way until
it locks in place with a little click.
● If you can see the red indicator on the upper side of
the button, it is not locked completely. Install it fully
until the red indicator cannot be seen. If not, it may
accidentally fall out of the radio, causing injury to you
or someone around you.
● Do not use force when installing the battery cartridge.
If the cartridge does not slide in easily, it is not being
inserted correctly.
● To remove the battery cartridge, slide it from the radio
while sliding the button on the front of the cartridge.
Indicating the remaining battery
capacity (Fig. 6-8)
1. Indicator lamps 2. Check button
Press the check button on the battery cartridge to
indicate the remaining battery capacity. The indicator
lamps light up for few seconds.
Indicator or lamps
Lighted
(For XGT and LXT battery
cartridges only)
(For XGT and LXT battery
cartridges only)
NOTE:
● Depending on the conditions of use and the ambient
temperature, the indication may differ slightly from
the actual capacity.
● The first (far left) indicator lamp will blink when the
battery protection system works.
Back up battery Installation (Fig. 9)
Keeping back up batteries inside the compartment
prevent stored data in preset memories from being lost.
1. Pull out the battery compartment locker to release
battery compartment. There are main battery pack
compartment and back up battery compartment.
2. Remove back up battery compartment cover and
insert 2 fresh UM-3 (AA sizes). Make sure the
batteries are with correct polarity as shown inside the
compartment. Replace the battery cover.
3. After back up batteries are inserted, insert the main
battery pack to power radio.
Using supplied AC power adaptor
Remove the rubber protector and insert the adaptor
plug into the DC socket on the right hand side of the
radio. Plug the adaptor into a standard mains socket
outlet. Whenever the adaptor is used, the battery pack
is automatically disconnected.
CAUTION:
● Always disconnected the AC power adapter
completely before moving the radio. If the AC
9 ENGLISH
Off Blinking
malfunctioned.
Remaining
capacity
75% ~ 100%
50% ~ 75%
25% ~ 50%
0% ~ 25%
Charge the
battery.
The battery
may have