Orion XTR2504 Bedienungsanleitung Seite 11

Four Channel stereo Configuration
• Channel 1/2 and channel 3/4 lowest recommended impedance is
2Ω stereo .
• Crossover mode, output, and gain configurations are indepen-
dently adjustable between the front and rear channels .
• two-channel or four-channel input can be used for this configu-
ration . For source unit fading, use the four-channel input mode .
• Channels 1/2 and channels 3/4 outputs can be individually config-
ured for highpass, low-pass, or full range operation .
_
+
1CH
2CH
+
_
Figure 10
Figura 10
Abbildung 10
_
+
© 2008 Directed Electronics. All rights reserved.
1CH
_
+
3CH
4CH
+
_
_
+
3CH
three Channel Configuration
• Channels 1/2 are configured for 2-channel stereo operation .
• Channel 1/2 lowest recommended impedance is 2
• Channels 3/4 are configured for a single channel bridged out-
+
put .
• Channel 3/4 lowest recommended bridged impedance is 4
• Crossover mode, output, and gain configurations are indepen-
dently adjustable between channels 1/2 and 3/4 .
• two-channel or four-channel input can be used for this configu-
ration . For source unit fading, use the four-channel input mode .
• Channel 1/2 and 3/4 outputs can be configured for high-pass, low- _
pass, or full range operation .
• Channel 3/4 outputs are configured for summed bridged opera-
tion for subwoofer
+
_
Figure 11 _
+ +
Figura 11
Abbildung 11
1CH
2CH
+
_ _
_
+
1CH
2CH
+
_
_ _
+
1CH
2CH
+ +
_
_
3CH
_
+
4CH
+
Ω stereo .
_
Ω .
3CH
4CH
+
_
+
1C
3CH
2C
+
_
4CH
10
_
+