Jam Audio Been There HX-HP202 Bedienungsanleitung Seite 3

SET UP
CHARGING YOUR HEADPHONES
The "Been There" headphones are powered by a
rechargeable battery. The headphones come pre-
charged; however, for optimal play time, be sure to
charge before first use.
A – Unwrap the charging cable and plug the micro
USB end into the charging port on the headphones.
B – Connect the larger USB plug to your computer
or a powered USB AC adapter. An AC adapter is not
included in the box, but you can use the one for
your cell phone or pick one up next time you're at
the store.
C – When the LED flashes red, it indicates that the
battery is low and it's time to plug in and recharge.
Charge for about 2 hours to get up to 14 hours of play
time; while charging, the light will stay solid red.
Once fully charged, the LED will turn off.
USE
A – TURN ON YOUR HEADPHONES
Long press the "play/pause" button for 3 seconds to
turn on your headphones.
B – CONNECTING TO A DEVICE
Once turned on, the headphones will immediately
search for a device to pair to; the LED will blink red
and blue alternately. Enable Bluetooth on your device.
From the Bluetooth menu, select "Been There." When
the device and Been There are connected, you will hear
a tone and the LED light will turn solid blue.
Once paired, your device and headphones will find
each other every time, as long as your device's
Bluetooth is on. If you're connecting to a computer,
you may have a few more steps on that end.
You'll have to get that information from the
computer company.
Depending on your device, you may be prompted to
enter a pairing code. If so, use "0000" as the code.
Holding down the "X" and "O" buttons at the same
time, for 5 seconds, will disconnect a paired device.
EN
You may also connect your device to Been There using
an aux cord, which is not included. When plugged in,
the light will turn solid red.
Been There
Been
There
2hrs 14hrs
...3s
0000
0000
...0.5s
3