Stûv TULOX 100 Montageanleitung Seite 13

1. Screw the lock on tightly with 3 cylinder head screws M6 x 35 mm or BSW ¼" x 35 mm.
Consider the female thread of the bolt work. The insertion of the screws must be without
force.
2. Lead the cable through the drill hole you have prepared in the secure storage unit door and
plug the cable connector on the rear side of the lock case into the provided jack.
3. Insert the axis through the key hole into the lock case.
4. Mark the axis for shortening approx. 9 to 10 mm in front of the external surface of the secure
storage unit door.
5. Pull the axis out of the lock, shorten it at the marked point and then re-insert it in the lock
case.
6. Plug the keypad´s base plate onto the axis and align it vertically.
7. Mark the drilling position for the fastening screws.
8. Completely remove the base plate again and drill the fastening holes with a spiral drill Ø 3.5
mm. Pay careful attention that the base plate is not contaminated with bore chips.
9. Replace the base plate. Pull the spare cable length into the inside of the unit. Attach the base
plate with the enclosed cylinder head screws. The wall of the base plate must not deform
during this process.
10. Insert the batteries (4 x 1.5V, AA, LR6) paying attention to the terminal direction and place the
cover on the base plate.
11. Check the proper function in accordance with the Operating Instructions with the door open.
Installation Instructions TULOX 100 + 200
Steinbach & Vollmann GmbH & Co. KG • 42579 Heiligenhaus - 13 -