Using A Chest Belt - Fuel CT 100 Benutzerhandbuch

Remarks:
1) This computer has an automatic on/off function so that it switches on when the pedals move or when
any button is pressed, and turns into stand-by mode automatically if no signal has been received for
approx. 4 minutes.
2) In case of any abnormal functions, disconnect the device from power source and reconnect after some
minutes.

Using a chest belt

1. Attach the transmitter to the elastic strap using the lock button.
2. Adjust the strap as tightly as possible as long as the strap is not too tight to remain
comfortable.
3. Position the transmitter with the logo centered in the middle of your torso facing
away from your chest (some people must position the transmitter slightly left of
center). Attach the final end of the elastic strap by inserting the round end and, using
the locking parts, secure the transmitter and strap around your chest.
4. Position the transmitter directly below the pectoral muscles.
5. Sweat is the best conductor to measure very minute heart beat electrical signals.
6. However, plain water can also be used to pre-wet the electrodes (2 ribbed oval areas on the reverse side of the
belt and both sides of the transmitter). It's also recommended that you wear the transmitter strap a few minutes
before your work out. Some users, because of body chemistry, have a more difficult time in achieving a strong,
steady signal at the beginning. After "warming up", this problem lessens.
Your workout must be within range - distance between transmitter/receiver – to achieve a strong steady signal.
7.
The length of range may vary somewhat but generally stay close enough to the console to maintain good,
strong, reliable readings. Wearing the transmitter directly on bare skin assures you of proper operation. If you
wish, you may wear the transmitter over a shirt. T o do so, wet the areas of the shirt that the electrodes will rest
upon.
Note: The transmitter is automatically activated when it detects activity from the user's heart. Additionally, it
automatically deactivates when it does not receive any activity. Although the transmitter is water resistant,
moisture can have the effect of creating false signals, so you should take precautions to completely dry the
transmitter after use to prolong battery life (estimated transmitter battery life is 2500 hours). The replacement
battery needs to be of the type CR2032.
54