D- Using Your Product - Ugur UDD 100 SC Bedienungsanleitung

D- USING YOUR PRODUCT

Start-up
WARNING!
This operating manual applies for various device models. Hardware scopes of the models may vary. There
may be differences in the pictures.
Clean inside and all accessories of your product before the first start up. (see page 26).
If your product has been shaken so much during the transportation and positioning, wait for one (1)
hour without running it. Thus, the compressor oil, which may enter into the system, will return back.
You may damage the compressor if you run it without considering this.
Insert your product's plug into an outlet with alternative current of 220-240V/50 Hz only, which has
been installed according to the regulations. (Picture 12)
You will hear a slight sound from the compressor when your product is running.
PICTURE 12
Setting Internal Temperature of Your Device
Internal temperature of your device has been factory set in a manner that it will protect your food without
causing them spoiled.
The thermostat of your product is located at the compressor section and it can be set to the desired level
only by the Authorized Uğur Service if requested (except the models with digital thermostat)
When you run your product at factory set value, you get the best result in terms of both the performance
and energy consumption.
Run your device empty for at least three (3) hours. Therefore inside of your product will be cooled down in the best
way.
NOTE
Internal temperature of your product can be set between -18°C ile -25°C (It can be set only by
Authorized Uğur Services)
47
EN