Operation; Preparing For Operation; Filling The Salt Reservoir - Inventum IVW6011A Benutzerhandbuch

Icon Name
P4 - Eco
P5 - Quick '30
P6 - Quick rinse
5

Operation

PREPARING FOR OPERATION

1. Do a check if the electricity and the water supply connections of the appliance match the values indicated in the
installation instructions.
2. Remove all packaging material inside the appliance.
3. Fill the salt reservoir. Refer to section
4. Fill the rinse aid reservoir. Refer to section

FILLING THE SALT RESERVOIR

For a good result the appliance needs soft (less calcareous) water. Salt is used to soften the water and it prevents
white lime residues on your dishes and the interior of the appliance.
Caution:
Only use salt that is suitable for a dishwasher. Do not use table salt.
Note:
Fill the salt reservoir when the salt indicator on the control panel is on.
1. Remove the lower basket.
2. Turn the cap (A) of the salt reservoir counter-clockwise to remove it.
3. Fill the salt reservoir with water.
Note:
You only have to fill the salt reservoir with water before first use of the appliance.
4. Put a funnel in the opening of the salt reservoir.
5. Fill the reservoir with salt until the overflow level.
6. Install the cap of the salt reservoir.
Caution:
Remove any spilled salt immediately and run a full program to prevent corrosion of the appliance.
SETTING THE LEVEL OF SALT CONSUMPTION
The salt consumption of the appliance depends on the level of water hardness.
40 • English
Description
Daily program for normally soiled dishes. The program
takes longer, but uses less water and slowly heats for
lower energy consumption.
Short program for lightly soiled dishes, such as cups and
glasses.
Fastest program for lightly soiled and recently used
dishes. The program is suitable for 4 place settings.
'Filling the salt reservoir'
.
'Filling the rinse aid reservoir'
.
Time
[min.]
221
30
15
(Figure 3)
(Figure 4)
(Figure 5)