Maintenance; Troubleshooting - Greencut GGT200L Betriebsanleitung

48
CUTTING HEAD ANGLE ADJUSTMENT
1. Press and hold the lock button (11).
2. Tilt the cutting head (10) to the desired position.
3. Release the locking button (11) and ensure that the head
engages in a locked position.

MAINTENANCE

Good maintenance will extend the life of the machine. Prolonged or constant use may require more intensive
maintenance for the machine to continue to function properly.
ATTENTION: Make sure the engine is completely shut down before performing any maintenance
or repair. This will eliminate any potential risk.
CLEANING
ATTENTION: Do not use solvents, chemicals or abrasives when cleaning the machine as this
may damage some surfaces.
• Use gloves or appropriate tools for cleaning. Do not do it with unprotected hands.
• Clean the machine after each use to ensure best performance and durability.
• It is recommended that the machine be raised when checking or maintaining the lower part of the cover, avoiding
tilting it so that fuel or oil does not spill.
• Use a slightly damp cloth, water and a mild detergent for cleaning.
• Make sure that all ventilation slots designed for heat dispersion are clean and free from obstructions or residues.
• Remove grass clippings, dirt, etc. from the underside of the cover and blades (the wash function on some models
makes this task easier).
• It is recommended to put a little oil on the blades after each use to avoid corrosion.

TROUBLESHOOTING

The table includes some of the most common problems, their causes and remedies.
PROBLEM
The battery is not charged.
The brushcutter
The battery is not properly inserted.
does not start.
The device is defective.
NOTE: If you are unable to resolve the problem, please contact the Official Technical Service.
POSSIBLE CAUSE SOLUTION
Charge the battery.
Put the battery in place.
Contact the official service department.