Renson Healthbox II Gebrauchsanweisung Seite 27

4.2 • Start calibration process on the main print board
• First complete the steps mentioned in section 4.
• The Status LED will blink red
• Calibration procedure:
press and hold INIT-button (>5sec.)
until the Status LED continuously
lights up red
• Feedback:
Feedback of the Status-LED:
- During calibration: lights up continuously
- During C-mode (calibration completed): no longer lights up
The feedback can also be read on the control switches (see section 4.1 and 4.3)
EN
27