Identification Of Parts; Assembling; Clothing; Operation - Texas Rt 450Tg Bedienungsanleitung

Identification of parts

See Figure.1
1 Bumper
2 Wheel
3 Cultivator

Assembling

 Attach the bumper to the engine block, fasten with bolt and nut see ill 1A, Fig1
 Attach upper handle onto the lower handle, adjust cables see ill 4A, Fig 1.
WARNING: Follow the user manual guide to fill the engine with oil and fuel.

Clothing

When working with the tiller, wear close-fitting work clothes,
sturdy work gloves, hearing protection and boots with non-skid
soles, and steel nose is compulsory.

Operation

Clean the area of all foreign items before use. Stone, glass, branches, etc. can damage
the tiller. Check that all bolts on the tiller are tightened.
Warning: Stay out of dashed zone, while starting the engine! Always start the
Start:
Set the throttle to full throttle. (Follow the instructions for starting the engine.)
•
• Turn the decompression lever (returns automatically after starting.)
(only RT450D)
• Slowly pull the engine starter cord until you feel resistance. Then pull sharply in one
long row. Never let the starter run back by itself, always follow it by hand.
• Regulate the gas until the engine has a smooth operation.
Stop: Place the throttle handle on minimum .Follow the guide in the user manual to stop.
Operating the handlebar
To use the black handle, the control stick must first be activated. By tilting the control stick
to the right or left side and then activate the black handle, the tiller will move forward or
backwards. See illustration , Fig.1
Wheel setup
The wheels can be set in neutral mode, which is an advantage when the machine has to
be transported. Additionally this feature enables the user to cultivate without using the
wheels pull the machine. In order to set the wheels in neutral/ lock mode do as shown in
illustration A and B, Fig.1
engine from dotted safety zone See fig 2
4 Handles
5 Throttle lever
6 Clutch Lever
19