Cleaning And Maintenance; Troubleshooting - BOMANN KS 7230.1 Bedienungsanleitung, Garantie

Cleaning and Maintenance

WARNING:
 Always disconnect the appliance from the power
supply before cleaning and user maintenance.
 Do not use steam cleaners for cleaning the appli-
ance; moisture could enter electrical components.
Risk of electric shock! Hot steam could damage
the plastic parts.
 The unit must be dry before restarting operation.
CAUTION:
 Do not use a wire brush or other sharp, abrasive
items.
 Do not use any acidic or abrasive detergents.
 Do not damage the refrigerant circuit.
Cleaning the appliance including interior
 Clean the appliance interior, the exterior surfaces,
the accessories and the door seal regularly with
warm water and mild detergent; or with a clean,
damp microfiber cloth without cleaning agent.
 Remove the appliance content and storage it at a
cool location.
 After everything was thoroughly dried, you can
restart the operation.
Depending on model:

the dust that has accumulated on the appliance
back and condenser (metal grille). To do this, use
a soft brush or a vacuum cleaner.
Defrosting
CAUTION:
Never use metal objects (e.g. knifes) to remove ice
from the evaporator. Otherwise it can be damaged.
To achieve better cooling and to save energy, defrost
the appliance regularly manual as follows:
 To start the defrosting process, turn the tempera-
ture control to the off state and disconnect the
appliance from the power supply.
Wipe at least once a year
 Remove the food items and keep covered at a
cool location.
 Once the ice has melted, empty the condensation
drip tray below the chilling compartment; wipe up
the condensation water and dry the unit interior.
 Then you may restart the appliance by connecting
the plug and turning the temperature control.
Changing the light
CAUTION:
Do NOT remove the cover of the light. The LED light
may be replaced / repaired in case of failure / defect
only by an authorized specialist.

Troubleshooting

Before you contact an authorized specialist
Problem Cause / Action
Unit is not
∙ Check the power supply / temper-
working
ature setting / ambient temperature.
properly or
∙ Unblock the ventilation openings,
at all
install the appliance freely.
Loading is
∙ Check the temperature setting /
too warm
ambient temperature. ∙ Open the
door only as long as necessary.
Loud noise
∙ Check the appliance position.
during op-
∙ See the section
eration
Water on
∙ Check the temperature setting /
the unit
the condensation drip tray.
bottom
Light does
∙ Check the power supply.
not work
∙ See
NOTE:
If a problem persists after following the steps above,
contact your trader or an authorized technician.
21
"Operating noise".
"Changing the light".