Olympus PPO-EP03 Bedienungsanleitung Seite 20

• Locations subject to vibrations
• Locations with high temperature and humidity or with severe
temperature changes
• Locations with volatile substances
3 Opening and closing at locations with much sand, dust, or dirt may
EN
impair the waterproof characteristic and cause water leakage. This
should be avoided.
4 This product does not soften impacts to the camera or lens in the Case
on which it is mounted. If, when the product is mounted on the Case,
the assembly is subjected to an impact or placed under heavy object,
damage to the camera or lens may result. Please handle it with
sufficient care.
5 Do not use the following chemicals for cleaning, corrosion prevention,
prevention of fogging, repair or other purposes. When these are used
for the Lens Port directly or indirectly (with the chemicals in vaporized
state), they may cause cracking under high pressure or other
problems.
Chemicals which cannot
be used
Volatile organic solvents,
chemical detergents
Anticorrosion agent
Commercial defogging
agents
Grease other than
specified silicone grease
Adhesive
6 In the event that you discover that water has leaked into the product,
stop using the camera underwater immediately, remove any moisture
adhered to the product, remove the camera and lens from the Case,
and consult a service center.
EN 20 EN 20
Do not clean the Lens Port with alcohol, gasoline,
thinner or other volatile organic solvents or with
chemical detergents etc. Use pure water or
lukewarm water.
Do not use anticorrosion agents. Wash with pure
water.
Do not use commercial defogging agents. Always
use the specified desiccant silica gel.
Use only the specified silicone grease for the
O-ring, as otherwise the O-ring surface may
deteriorate and water leakage may occur.
Do not use adhesive for repairs or other purposes.
When repair is required, please contact your local
service station or dealer.
Explanation